Routing
296
M4300 Series and M4300-96X Fully Managed Switches User Manual
Configure Routing Parameters for the Switch
You can configure routing parameters for the switch as opposed to an interface.
To configure routing parameters for the switch:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Routing> IP >
Advanced > IP Configuration
.
6. Use Routing Mode to select Enable or Disable.
You must enable routing for the switch before you can route through any of the interfaces.
The default value is Disable.
7. Use ICMP Echo Replies to select Enable or Disable.
If you select Enable, then only the router can send ECHO replies. By default ICMP echo
replies are sent for echo requests.
8. Use ICMP Redirects to select Enable or Disable.
If it is enabled globally and on interface level then only the router can send ICMP
redirects.
9. Use ICMP Rate Limit Interval to control the ICMP error packets by specifying the number
of ICMP error packets that are allowed per burst interval.
To Next Page
Loading...
