Maintenance and Troubleshooting
675
M4300 Series and M4300-96X Fully Managed Switches User Manual
The default value is 33434. The range is 1- 65535.
13. Enter the Size of the probe packets.
The default value is 0. The range is 0 to 39936.
14. Enter the Source IP address or interface to use when sending the echo request packets.
If source is not required, select None as the source option. Possible values are as
follows:
• None.
The source address of the ping packet would be the address of the default
outgoing interface.
• IP Address
. The source IP address to use when sending the echo request packets.
This field is shown when
IP Address is selected as the source option.
• Interface. The interface to use when sending the echo request packets.
This field is
shown when Interface is selected as the source option.
Note: Values configured in the fields on this page are not saved to the switch.
As a result, refreshing the page sets these fields to the default values.
15. Click the Apply button.
A traceroute request is sent to the specified IP address or host name. The results are
displayed below the configurable data in the
T
raceRoute Results area.
The Results field displays the traceroute IPv4 result after the switch sends a traceroute
request to the specified IP address or host name.
Traceroute IPv6
Use this page to tell the switch to send a traceroute request to a specified IPv6 address or
host name. You can use this to discover the paths packets take to a remote destination.
Once you click the Apply button, the switch sends a traceroute and the results are displayed
below the configurable data.
If a reply to the traceroute is received, the following message displays:
1 a:b:c:d:e:f:g 9869 usec 9775 usec 10584 usec
2 0:0:0:0:0:0:0:0 0 usec * 0 usec * 0 usec *
Hop Count = p Last TTL = q Test attempt = r Test Success = s.
To use traceroute IPv6:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
To Next Page
Loading...
