Configure System Information
80
M4300 Series and M4300-96X Fully Managed Switches User Manual
The Dynamic Host Mapping table shows host name-to-IP address entries that the switch
learned. The following table describes the dynamic host fields.
Configure the Switch Database Management Template
Preference
A Switch Database Management (SDM) template is a description of the maximum resources
a switch or router can use for various features. Different SDM templates allow different
combinations of scaling factors, enabling different allocations of resources depending on how
the device is used. In other words, SDM templates enable you to reallocate system resources
to support a different mix of features based on your network requirements.
Note: If you attach a unit to a stack and its template does not match the
stack’s template, then the new unit automatically reboots using the
template used by the other stacking members. To avoid the automatic
reboot, first set the template to the SDM template used by existing
members of the stack. Then power off the new unit, attach it to the
stack, and power it on.
You can configure SDM template preferences for the switch.
To configure the SDM Template Preference settings:
1. Launch a web browser.
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is
admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
Table 25. DNS Dynamic Host Mapping
Field Description
Host Lists the host name that you assign to the specified IP address.
Total Amount of time since the dynamic entry was first added to the table.
Elapsed Amount of time since the dynamic entry was last updated.
Type The type of the dynamic entry.
Addresses Lists the IP address associated with the host name.
To Next Page
Loading...
