Configure System Information
81
M4300 Series and M4300-96X Fully Managed Switches User Manual
The System Information page displays.
5. Select System > Management > SDM Template Preference.
6. Use SDM Next Template ID
to configure the next active template.
It is active only after the next reboot. To revert to the default template after the next
reboot, use the Default option. Possible values are as follows:
• Default
• IPv4 Data Center Plus Generic
• Dual IPv4 and IPv6 Data Center Generic
• IPv4 Data Center Plus Mixed Native and M4300-96X
• IPv4 Data Center Plus M4300-96X
• IPv4 Data Center Plus Native
• Dual IPv4 and IPv6 Data Center Native
• Dual IPv4 and IPv6 Data Center Plus Mixed Native and M4300-96X
• Dual IPv4 and IPv6 Data Center M4300-96X
Note: The templates with the Native keyword are supported only on the
M4300-24X24F and M4300-48X stand-alone switches and on a
homogenous stack of M4300-24X24F and M4300-48X switches.
To Next Page
Loading...
