NETGEAR M4300 User Manual

Manage Device Security
557
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. Use one of the following methods to select a port:
• In the Go To
Port field, enter the interface in the unit/slot/port format and click on the
Go button.
• Next to the Port column, select the check box for the port that you want to configure,
select multiple check boxes to apply the same setting to all selected ports, or select
the check box in the table heading to apply the same settings to all ports.
7. Configure broadcast storm control:
• Recovery Mode. Enable or disable this option. When you specify Enable and the
broadcast traffic on the specified port exceeds the configured threshold, the switch
blocks (discards) the broadcast traf
fic. The factory default is Enable.
• Recovery Level Type. Specify the recovery level as a percentage of link speed or as
packets per second.
• Recovery Level
. Specify the threshold at which storm control activates. The factory
default is 5 percent of port speed for pps type.
• Control Action. Specify the action that occurs when the configured threshold for the
broadcast storm is exceeded. Y
ou can select the port to be shut down or traffic on the
port to be rate-limited. The default is RateLimit.
8. Configure broadcast storm control:
• Recovery Mode. Enable or disable this option. When you specify Enable and the
multicast traffic on the specified port exceeds the configured threshold, the switch
blocks (discards) the multicast traf
fic. The factory default is Enable.
• Recovery Level Type. Specify the recovery level as a percentage of link speed or as
packets per second.
• Recovery Level
. Specify the threshold at which storm control activates. The factory
default is 5 percent of port speed for pps type.
9. Configure broadcast storm control:
• Recovery Mode. Enable or disable this option. When you specify Enable and the
unicast traffic on the specified port exceeds the configured threshold, the switch
blocks (discards) the unicast traffic. The factory default is Enable.
• Recovery Level Type. Specify the recovery level as a percentage of link speed or as
packets per second.
• Recovery Level
. Specify the threshold at which storm control activates. The factory
default is 5 percent of port speed for pps type.
10. Click the Apply
button.
Your settings are saved.

NETGEAR M4300 Specifications

General

Model	M4300
Form Factor	Rack-Mountable
Layer	Layer 3
Stackable	Yes
Managed	Yes
Memory	Varies by model
Flash Memory	Varies by model
Warranty	Lifetime
Ports	Varies by model (24 or 48 ports)
PoE	Available on some models
Port Speed	10/100/1000 Mbps, 10Gbps on uplinks
Forwarding Rate	Varies by model
Jumbo Frame Support	Yes
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1X
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 50° C (32° to 122° F)
Power Supply	Internal
Uplink Ports	Varies by model (SFP/SFP+ or 10G SFP+)