NETGEAR M4300 - Page 310

Routing
310
M4300 Series and M4300-96X Fully Managed Switches User Manual
2. In the address field of your web browser, enter the IP address of the switch.
The login window opens.
3. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Routing> IPv6 >
Advanced > Prefix Configuration.
6. From the
Interface list, select the interface.
When the selection is changed, a page update occurs, causing all fields to be updated for
the newly selected port. All physical interfaces are valid.
7. In the
IPv6 Prefix field, specify the IPv6 prefix for an interface.
8. In the Prefix Length field, specify the IPv6 prefix length for an interface.
9. In the EUI64 list, select to Enable or Disable the specified 64-bit unicast prefix.
10. In the V
alid Life Time field, specify the router advertisement per prefix time.
This is the amount of time allowed to consider the prefix valid for the purpose of on-link
determination. The valid life time is 0 to 4294967295.
1
1. In the Preferred Life Time field, specify the router advertisement per prefix time.
An autoconfigured address generated from this prefix is preferred. The preferred life time
must be in the range 0 to 4294967295.
12. From the Onlink Flag list, select Enable or Disable.
This specifies whether the selected prefix can be used for on-link determination. The
default is Enable.
13. In the Autonomous Flag list, select Enable or Disable.
This specifies whether the selected prefix can be used for autonomous address
configuration.
The default value is Enable.
14. Click the Add
button.
The IPv6 address is added to the interface.