Configure Switching Information
179
M4300 Series and M4300-96X Fully Managed Switches User Manual
5. Select Switching> VLAN > Basic > VLAN Configuration.
6. To reset VLAN settings to their default values, select the Reset Configuration check box.
The factory default values are as follows:
• All ports are assigned to the default VLAN of 1.
• All ports are configured with a PVID of 1.
• All ports are configured to an
Acceptable Frame
Types value of Admit All Frames.
• All ports are configured with Ingress Filtering disabled.
• All ports are configured to transmit only untagged frames.
• GVRP is disabled on all ports and all dynamic entries are cleared.
All VLANs, except for the default VLAN, are deleted.
7. Specify the internal VLAN settings.
The Internal VLAN Configuration section displays the allocation base and the allocation
mode of internal VLAN.
a. Use Internal VLAN
Allocation Base to specify the VLAN allocation base for the
routing interface.
The default base range of the internal VLAN is 1 to 4093.
b. Select the Internal VLAN Allocation Policy Ascending
or Descending radio
button.
This specifies a policy for the internal VLAN allocation.
8. Use VLAN ID to specify the VLAN identifier for the new VLAN.
The range of the VLAN ID is 1 to 4093.
9. Use the optional VLAN Name field to specify a name for the VLAN.
To Next Page
Loading...
