NETGEAR M4300 User Manual

Configure Switching Information
250
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. Use Querier Admin Mode to select the administrative mode for MLD snooping for the
switch. The default is Disable.
7. Use Querier Address to specify the snooping querier address to be used as source
address in periodic MLD queries.
This address is used when no address is configured on the VLAN on which query is being
sent.
The supported IPv6 formats are x:x:x:x:x:x:x:x and x::x.
8. Use MLD Version
to specify the MLD protocol version used in periodic MLD queries.
9. Use Query Interval(secs) to specify the time interval in seconds between periodic queries
sent by the snooping querier.
The query interval must be a value in the range of 1 to 1800.
The default value is 60.
10. Use Querier Expiry Interval(secs) to specify the time interval in seconds after which the
last querier information is removed.
The querier expiry Interval must be a value in the range of 60 to 300. The default value is
60. The page displays VLAN IDs enabled for the MLD snooping querier
.
11. Click the Apply button.
Your settings are saved.

NETGEAR M4300 Specifications

General

Model	M4300
Form Factor	Rack-Mountable
Layer	Layer 3
Stackable	Yes
Managed	Yes
Memory	Varies by model
Flash Memory	Varies by model
Warranty	Lifetime
Ports	Varies by model (24 or 48 ports)
PoE	Available on some models
Port Speed	10/100/1000 Mbps, 10Gbps on uplinks
Forwarding Rate	Varies by model
Jumbo Frame Support	Yes
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1X
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 50° C (32° to 122° F)
Power Supply	Internal
Uplink Ports	Varies by model (SFP/SFP+ or 10G SFP+)