NETGEAR M4300 - Page 361

OSPF and OSPFv3
361
M4300 Series and M4300-96X Fully Managed Switches User Manual
13. In the Iftransit Delay Interval field, enter the OSPF transit delay for the specified interface.
This specifies the estimated number of seconds it takes to transmit a link state update
packet over the selected interface. The valid values range from 1 to 3600 seconds (1
hour).
The default value is 1 second.
14. Configure MTU Ignore by selecting Enable or Disable from the list.
MTU Ignore disables OSPF MTU mismatch detection on received database description
packets. The default value is Disable
(MTU mismatch detection is enabled).
15. Configure Passive Mode by selecting Enable or Disable from the list.
Make an interface passive to prevent OSPF from forming an adjacency on an interface.
OSPF advertises networks attached to passive interfaces as stub networks. Interfaces
are not passive by default, meaning that the passive mode default is Disable.
16. In the OSPF Network Type list, select
Broadcast or Point-to-Point.
OSPF selects a designated router and originates network LSAs only for broadcast
networks. No more than two OSPF routers can be present on a point-to-point link. The
default network type for Ethernet interfaces is broadcast
.
17. Select an Authentication Type other than
None by selecting from the list.
The choices are as follows:
• None. This is the initial interface state. If you select this option from the list, no
authentication protocols are run.
The default is None.
• Simple. Y
ou are prompted to enter an authentication key. This key is included, in the
clear, in the OSPF header of all packets sent on the network. All routers on the
network must be configured with the same key.
• Encrypt. Y
ou are prompted to enter an authentication key and an authentication ID.
Encryption uses the MD5 Message-Digest algorithm. All routers on the network must
be configured with the same key and ID.
18. Enter the Authentication Key ID to be used for authentication.
You are prompted to enter an ID only if you select Encrypt as the authentication type. The
ID is a number between 0 and 255, inclusive.
19. In the Metric Cost field, enter the link cost.
OSPF uses this value in computing shortest paths. The range is from 1 to 65,535. The
default is 1.
20. Click the Apply button.
Your settings are saved.