NETGEAR M4300 User Manual

Multicast Routing
444
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. From the list of interfaces, select the Interface.
7. Enter the C-BSR Hash Mask Length to be advertised in bootstrap messages.
This hash mask length is used in the hash algorithm for selecting the RP for a particular
group.
The valid values are from 0 to 128.
The default value is 126.
8. In the Priority field, enter the priority of the C-BSR.
9. Enter the Advertisement Interval value of the C-BSR in seconds.
The default value is 60.
To remove the configured Hash Mask Length, and Priority values and restore them to the
default values, click the Delete button.
10. Click the Apply button.
Your settings are saved.
The following table describes the nonconfigurable information that is displayed.
Table 171. IPv6 PIM BSR Candidate Configuration
Field Description
BSR Expiry Time (hh:mm:ss) Time (in hours, minutes and seconds) in which the learned elected
bootstrap router (BSR) expires.
IP Address The IP address of the elected BSR.
Next bootstrap Message
(hh:mm:ss)
Time (in hours, minutes, and seconds) in which the next bootstrap
message is due from this BSR.
Next Candidate RP Advertisement
(hh:mm:ss)
Time (in hours, minutes, and seconds) in which the next candidate RP
advertisement is sent.

NETGEAR M4300 Specifications

General

Model	M4300
Form Factor	Rack-Mountable
Layer	Layer 3
Stackable	Yes
Managed	Yes
Memory	Varies by model
Flash Memory	Varies by model
Warranty	Lifetime
Ports	Varies by model (24 or 48 ports)
PoE	Available on some models
Port Speed	10/100/1000 Mbps, 10Gbps on uplinks
Forwarding Rate	Varies by model
Jumbo Frame Support	Yes
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1X
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 50° C (32° to 122° F)
Power Supply	Internal
Uplink Ports	Varies by model (SFP/SFP+ or 10G SFP+)