NETGEAR M4300 - Page 468

Configure Quality of Service
468
M4300 Series and M4300-96X Fully Managed Switches User Manual
4. Click the Login button.
The System Information page displays.
5. Select QoS> DiffServ > DiffServ Wizard.
6. Use Traffic Type to define the DiffServ Class.
T
raffic type options are: VOIP, HTTP, FTP, Telnet, and
Every.
7. Ports displays the ports which can be configured to support a DiffServ policy.
The DiffServ policy is added to selected ports.
8. Use Enable Policing to add policing to the DiffServ policy
.
The policing rate to be applied.
9. Specify the Committed Rate:
• When Policing
is enabled, the committed rate is applied to the policy and the policing
action is set to conform.
• When Policing is disabled, the committed rate is not applied and the policy is set to
markdscp.
10. Specify the Outbound Priority:
• When Policing is enabled, Outbound Priority defines the type of policing conform
action where: High sets action to markdscp ef, Med sets the action to markdscp af31,
and Low sets the action to send.
• When Policing is disabled, Outbound Priority defines the policy where: High sets the
policy to mark ipdscp ef, Med sets policy to mark ipdscp af31, and Low sets the policy
to mark ipdscp be.
11. Click the Apply button.
Your settings are saved.