NETGEAR M4300 - Page 51

Configure System Information
51
M4300 Series and M4300-96X Fully Managed Switches User Manual
6. Use the Loopback Interface Type list to select IPv4 or IPv6 loopback interface.
7. In the Loopback ID list, select a list of currently configured loopback interfaces.
8. In the Primary IP
Address
field, enter the primary address for this interface in
dotted-decimal notation.
This option is visible when IPv4 loopback is selected.
9. In the Primary IP Subnet Mask field, enter the primary IPv4 subnet mask in dotted-decimal
notation.
This option is visible when IPv4 loopback is selected.
10. In the Secondary IP
Address
field, enter the secondary IP address in dotted-decimal
notation.
This input field is visible only when Add Secondary is selected. This option is visible
when IPv4 loopback is selected.
1
1. In the Secondary Subnet Mask field, enter the secondary subnet mask for this interface in
dotted-decimal notation.
This input field is visible only when Add Secondary is selected. This option is visible
when IPv4 loopback is selected.
12. In the
IPv6 mode field, enable IPv6 on this interface using the IPv6 address.
This option is configurable before you specify an explicit IPv6 address. This option is
visible when IPv6 loopback is selected.
13. Use the IPv6 Address field to enter the IPv6 address in the format prefix/length.
This option is visible when IPv6 loopback is selected.
14. Use the EUI64 field to optionally specify the 64-bit extended unique identifier (EUI-64).
This option is visible when IPv6 loopback is selected.
15. Click the Apply button.
Your settings are saved.