Monitor the System
638
M4300 Series and M4300-96X Fully Managed Switches User Manual
3. Enter the user name and password.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
4. Click the Login button.
The System Information page displays.
5. Select Monitoring > Logs > T
rap Logs.
The page also displays information about the traps that were sent.
6. To clear all the counters, click the Clear button.
This resets all statistics for the trap logs to the default values.
The following table describes the
Trap Log information displayed on the page.
Table 222. Trap Logs
Field Description
Number of Traps Since Last
Reset
The number of traps that occurred since the switch last rebooted.
Trap Log Capacity The maximum number of traps stored in the log. If the number of traps exceeds
the capacity
, the entries overwrite the oldest entries.
Number of
Traps since log
last viewed
The number of traps that occurred since the traps were last displayed.
Displaying the traps by any method (terminal interface display, web display
,
upload file from switch, and so on) causes this counter to be cleared to 0.
Log The sequence number of this trap.
System Up Time The time when this trap occurred, expressed in days, hours, minutes and
seconds, since the last reboot of the switch.
Trap Information identifying the trap.
To Next Page
Loading...
