Configure System Information
78
M4300 Series and M4300-96X Fully Managed Switches User Manual
7. Enter the DNS Default domain Name to include in DNS queries.
When the system is performing a lookup on an unqualified host name, this field is
provides the domain name (for example, if default domain name is netgear.com and the
user enters test, then test is changed to test.netgear
.com to resolve the name). The
length of the name must not be longer than 255 characters.
8. Use Retry Number to specify the number of times to retry sending DNS queries to the DNS
server.
This number ranges from 0 to 100.
The default value is 2.
9. Use Response Timeout (secs) to specify the amount of time, in seconds, to wait for a
response to a DNS query
.
This time-out ranges from 0 to 3600. The default value is 3.
10. Specify the Source Interface to use for DNS.
Possible values are as follows:
• None
• VLAN 1
• Routing interface
• Routing VLAN
• Routing loopback interface
• T
unnel interface
• Service port
By default VLAN 1 is used as the source interface.
1
1. T
o specify the DNS server to which the switch sends DNS queries, do the following:
a. In the
DNS Server Address field in the DNS Server Configuration table, enter an IP
address in standard IPv4 or IPv6 dot notation.
b. Click the Add
button.
The server is added to the table. You can specify up to eight DNS servers. The
precedence is set in the order that you add the servers.
12. T
o remove a DNS server from the DNS Server Configuration table, do the following:
a. Select the check box for the server.
b. Click the
Delete button.
Note: If you click the Delete button without selecting a DNS server, all the
DNS servers are deleted from the table.
13. Click the Apply button.
Your settings are saved.
To Next Page
Loading...
