UCM630X Series User Manual
Version 1.0.11.10
Table 30: Global Policy Parameters – Phone Settings
Configure the default dial plan rule. For syntax and examples, please refer
to the user manual of the SIP devices to be provisioned for more details.
When enabled, “Do Not Disturb”, “Call Forward” and other call features can
be used via the local feature code on the phone. Otherwise, the ITSP
feature code will be used.
If set to “Yes”, pressing the number key “#” will immediately dial out the
input digits.
If set to “Yes”, the phone will automatically turn on the speaker phone to
answer incoming calls after a short reminding beep, based on the SIP
Call-Info header sent from the server/proxy.
The default setting is enabled.
Configure if NAT traversal mechanism is activated.
If set to “Yes”, this parameter will force random generation of both the
local SIP and RTP ports.
Configure call progress tones including ring tone, dial tone, second dial
tone, message waiting tone, ring back tone, call waiting tone, busy tone,
and reorder tone using the following syntax:
f1=val, f2=val[, c=on1/ off1[- on2/ off2[- on3/ off3]]];
• Frequencies are in Hz and cadence on and off are in 10ms).
• “on” is the period (in ms) of ringing while “off” is the period of silence.
Up to three cadences are supported.
• Please refer to the user manual of the SIP devices to be provisioned
for more details
Select “Default Mode” or “Toggle Headset/Speaker” for the Headset key.
Please refer to the user manual of the SIP devices to be provisioned for
more details.
To Next Page
Loading...
Need help?
General
