UCM630X Series User Manual
Version 1.0.11.10
Table 82: Multicast Paging Configuration Parameters
Configure paging/intercom group name.
Select “Multicast Paging”.
Configure the paging/intercom group extension.
If enabled, a caller can enter *82 before the paging group extension to start a
delayed paging call. In a delayed paging call, the system will prompt the caller
to record a message. Once the messaging is recorded and saved, and the
configured delay has passed, the paging call will be sent out. When a paging
group member answers the call, the recorded message will be played, and the
call will end after it is finished playing.
Configure the amount of delay in seconds after a message is recorded to send
out the delayed paging call. Default is 5 seconds.
The allowed multicast IP address range is 224.0.1.0 - 238.255.255.255.
Note: This field appears only when “Type” is set to “Multicast Paging”.
Specify the maximum call duration in seconds. The default value 0 means no
limit.
This option is to set a custom prompt for a paging/intercom group to announce
to caller. Click on ‘Prompt’, it will direct the users to upload the customized voice
prompts.
Note: Users can also refer to the page PBX Settings→Voice Prompt→Custom
Prompt, where they could record new prompt or upload prompt files.
Select which extensions are allowed to use the paging/intercom feature for this
paging group.
Specify port for multicast paging.
Note: This field appears only when “Type” is set to “Multicast Paging”.
To Next Page
Loading...
Need help?
General
