UCM630X Series User Manual
Version 1.0.11.10
setting is “None”.
• None: Disable Fax.
• Fax Gateway: If selected, the UCM630X can support the conversation and
processing of Fax data from T.30 to T.38 or T.38 to T.30. only for FXS ports.
• Fax Detection: During a call, the fax signal from the user/trunk will be detected,
and the received fax will be sent to the email address configured for the user. If
an email address has been configured for the user, the fax will be sent to the
Default Email Address configured in Fax/T.38->Fax Settings.
Table 50: FXS Extension Configuration Parameters→Features
Call Forward
Unconditional
Configure the Call Forward Unconditional target number. If not configured, the Call
Forward Unconditional feature is deactivated. The default setting is deactivated.
Select time condition for Call Forward Unconditional. CFU takes effect only during the
selected time condition. The available time conditions are “Office Time”, “Out of Office
Time”, “Holiday”, “Out of Holiday”, “Out of Office Time or Holiday”, and “Specific”.
Note:
• “Specific” has higher priority to “Office Times” if there is a conflict in terms of time
period.
• Specific time can be configured on the bottom of the extension configuration
dialog. Scroll down the add Time Condition for a specific time.
• Office Time and Holiday could be configured on page System Settings→Time
Settings→Office Time/Holiday page.
Configure the Call Forward No Answer target number. If not configured, the Call
Forward No Answer feature is deactivated. The default setting is deactivated.
To Next Page
Loading...
Need help?
General
