Grandstream Networks UCM630X Series - ARP Settings; Table 13: ARP Settings; Figure 28: GXP2160 Web Access Using UCM6302 Port Forwarding

P a g e | 89
UCM630X Series User Manual
Version 1.0.11.10
Figure 28: GXP2160 Web Access using UCM6302 Port Forwarding
ARP Settings
The ARP settings can be configured under Web GUI→System Settings→Network Settings→ARP Settings
Table 13: ARP Settings
ARP GC
Threshold 1
A minimum number of entries to keep. The garbage collector will not purge entries
if there are fewer than this number. The default value is 128.
ARP GC
Threshold 2
Threshold when garbage collector becomes more aggressive about purging
entries. Entries older than 5 seconds will be cleared when over this number. The
default value is 512.
ARP GC
Threshold 3
The maximum number of non-PERMANENT neighbor entries allowed. Increase
this when using large numbers of interfaces and when communicating with large
numbers of directly connected peers. The default value is 1024.