Grandstream Networks UCM630X Series - Configure Pickup Feature Code

P a g e | 380
UCM630X Series User Manual
Version 1.0.11.10
Figure 199: Edit Pickup Group
Configure Pickup Feature Code
When picking up the call for the pickup group member, the user only needs to dial the pickup feature code. It is
not necessary to add the extension number after the pickup feature code. The pickup feature code is configurable
under Web GUI→Call Features→Feature Codes.
The default feature code for call pickup extension is *8, otherwise if the person intending to pick up the call knows
the ringing extension they can use ** followed by the extension number in order to perform the call pickup
operation. The following figure shows where you can customize these features codes