Destination Number: The number to be dialed for detecting. This number could be a cell phone number
or another PSTN number that can be reached from the source channel PSTN number.
5. Click "Detect" to start detecting. The source channel will initiate a call to the destination number. For "Auto
Detect", the call will be automatically answered. For "Semi-auto Detect", the UCM630X Web GUI will display
a prompt to notify the user to answer or hang up the call to finish the detecting process.
6. Once done, the detected result will show. Users could save the detecting result as the current UCM630X
settings.
Table 59: PSTN Detection for Analog Trunk
Select "Auto Detect" or "Semi-auto Detect" for PSTN detection.
• Auto-Detect
Please make sure two or more channels are connected to the
UCM630X and in idle status before starting the detection. During the
detection, one channel will be used as the caller (Source Channel) and
another channel will be used as a callee (Destination Channel). The
UCM630X will control the call to be established and hang up between
caller and callee to finish the detection.
• Semi-auto Detect
Semi-auto detection requires answering or hanging up the call
manually. Please make sure one channel is connected to the
UCM630X and in idle status before starting the detection. During the
detection, the source-channel will be used as a caller and send the
call to the configured Destination Number. Users will then need to
follow the prompts in Web GUI to help finish the detection.
The default setting is "Auto Detect".
To Next Page
Loading...
Need help?
General
