UCM630X Series User Manual
Version 1.0.11.10
PBX SETTINGS
This section describes internal options that have not been mentioned in previous sections yet. The settings in
this section can be applied globally to the UCM630X, including general configurations, jitter buffer, RTP settings,
ports config and STUN monitor. The options can be accessed via Web GUI→PBX Settings→General Settings.
PBX Settings/General Settings
Table 105: Internal Options/General
Configure the global CallerID used for all outbound calls when no other
CallerID is defined with higher priority. If no CallerID is defined for extension
or trunk, the global outbound CID will be used as CallerID.
Configure the global CallerID Name used for all outbound calls. If configured,
all outbound calls will have the CallerID Name set to this name. If not, the
extension's CallerID Name will be used.
Configure the number of seconds to ring an extension before the call goes
to the user's voicemail box. The default setting is 60.
Note: This is the global value used for each extension if "Ring Timeout" field
is left empty on the extension configuration page.
Configure the maximum duration of call-blocking.
Maximum Call Duration (s)
The maximum call duration (in seconds). The default value 0 means no limit.
The amount of seconds before the maximum call duration is reached to play
the warning tone to the caller.
Warning Repeat Interval (s)
The amount of seconds that must pass after the first warning tone before
another warning tone is played.
Enable 486 to Failover
Trunk
Reroutes failed outbound calls that receive a 486 response through the
failover trunk to retry the call. If disabled, calls that receive a 486 response
will be terminated.
To Next Page
Loading...
Need help?
General
