Grandstream Networks UCM630X Series User Manual

P a g e | 445
UCM630X Series User Manual
Version 1.0.11.10
SIP Settings/MISC
Table 110: SIP Settings/Misc
Outbound SIP Registrations
Register Timeout
Configure the register retry timeout (in seconds). The default setting is 20.
Register Attempts
Configure the number of registration attempts before the UCM630X gives up. The
default setting is 0, which means the UCM630X will keep trying until the server
side accepts the registration request.
Video
Max Bit Rate (kb/s)
Configure the maximum bit rate (in kb/s) for video calls. The default setting is 384.
Support SIP Video
Select to enable video support in SIP calls. The default setting is "Yes".
Reject Non-Matching
INVITE
If enabled, when rejecting an incoming INVITE or REGISTER request, the
UCM630X will always reject with "401 Unauthorized" instead of notifying the
requester whether there is a matching user or peer for the request. This reduces
the ability of an attacker to scan for valid SIP usernames. Default setting is "No".
SDP Attribute Passthrough
Enable Attribute
Passthrough
If enable, and if the service does not know the attribute of FEC/FECC/BFCP, then
the attribute will be passthrough.
Early Media
Enable Use Final SDP
If enabled, call negotiation will use final response SDP.
Ignore 180 Response
If enabled, ringing indication after 183 response will be ignored.
Blind Transfer
Allow callback when
blind transfer fails
If enabled, the UCM will call back to the transferrer when blind transfer fails
(reason of failure includes busy and no answer).
Note: This feature takes effect only on internal calls.
Blind transfer timeout
Configure the timeout in (s) for the transferrer waiting for the destination to
answer. Default is 60s.

Grandstream Networks UCM630X Series Specifications

General

Brand	Grandstream Networks
Model	UCM630X Series
Category	Conference System
Language	English