Grandstream Networks UCM630X Series User Manual

P a g e | 414
UCM630X Series User Manual
Version 1.0.11.10
CALL FEATURES
The UCM630X supports call recording, transfer, call forward, call park and other call features via feature code.
This section lists all the feature codes in the UCM630X and describes how to use the call features.
Feature Codes
Table 100: UCM630X Feature Codes
Feature Maps
Blind Transfer
• Default code: #1
• Enter the code during active call. After hearing "Transfer", you
will hear dial tone. Enter the number to transfer to. Then the
user will be disconnected, and transfer is completed.
• Options:
Disable
Allow Caller: Enable the feature code on caller side only.
Allow Callee: Enable the feature code on callee side only.
Allow Both: Enable the feature code on both caller and callee.
Attended Transfer
• Default code: *2
• Enter the code during active call. After hearing "Transfer", you
will hear the dial tone. Enter the number to transfer to and the
user will be connected to this number. Hang up the call to
complete the attended transfer. In case of the called party does
not answer, users could press *0 to cancel the call and retrieve
the first call leg.
• Options:
Disable
Allow Caller: Enable the feature code on caller side only.
Allow Callee: Enable the feature code on callee side only.

Grandstream Networks UCM630X Series Specifications

General

Brand	Grandstream Networks
Model	UCM630X Series
Category	Conference System
Language	English