UCM630X Series User Manual
Version 1.0.11.10
The number that the trunk will try to use when making outbound calls.
CID priority from highest to lowest is as follows:
From User (register trunk only) >>> Inbound Call CID (if Keep Original CID is
enabled and the call is originally from another trunk) >>> Trunk CID (Keep Trunk
CID enabled) >>> DOD CID >>> Extension CID >>> Register Trunk Username
(Keep Trunk CID disabled) >>> Global Outbound CID.
Note 1: Certain providers may ignore this CID.
Note 2: If this CID contains an asterisk (*), call recordings from this trunk might be
lost when saving them to NAS storage.
Configure the new name of the caller when the extension has no CallerID Name
configured.
Table 64: IAX Register Trunk Configuration Parameters
Configure a unique label to identify this trunk when listed in outbound rules,
inbound rules, etc.
Configure the IP address or URL for the VoIP provider’s server of the trunk.
If enabled, the trunk CID will not be overridden by the extension's CID when the
extension has CID configured. The default setting is "No".
If selected, the trunk will be disabled.
Configure the Caller ID. This is the number that the trunk will try to use when
making outbound calls. For some providers, it might not be possible to set the
CallerID with this option and this option will be ignored.
Important Note: When making outgoing calls, the following priority order rule will
be used to determine which CallerID will be set before sending out the call :
From the user (Register Trunk Only) → CID from inbound call (Keep Original CID
Enabled) → Trunk Username/CallerID (Keep Trunk CID Enabled) → DOD →
Extension CallerID Number → Trunk Username/CallerID (Keep Trunk CID
Disabled) → Global Outbound CID.
To Next Page
Loading...
Need help?
General
