UCM630X Series User Manual
Version 1.0.11.10
Configure the name of the caller to be displayed when the extension has no
CallerID Name configured.
Enter the username to register to the trunk from the provider.
Enter the password to register to the trunk from the provider.
Select audio and video codec for the VoIP trunk. The available codecs are: PCMU,
PCMA, GSM, AAL2-G.726-32, G.726, G.722, G.729, G.723, iLBC, ADPCM,
H.264, H.265, H.263, H.263p and VP8.
Enable Heartbeat
Detection
If enabled, the UCM630X will regularly send SIP OPTIONS to the device to check
if the device is still online. The default setting is "No".
When the "Enable Heartbeat Detection" option is set to "Yes", configure the interval
(in seconds) of the SIP OPTIONS message sent to the device to check if the device
is still online. The default setting is 60 seconds.
Maximum Number of
Call Lines
The maximum number of concurrent calls using the trunk. The default setting is 0,
which means no limit.
Table 65: IAX Peer Trunk Configuration Parameters
Configure a unique label to identify this trunk when listed in outbound rules,
inbound rules, etc.
Configure the IP address or URL for the VoIP provider’s server of the trunk.
If enabled, the trunk CID will not be overridden by the extension's CID when the
extension has CID configured. The default setting is "No".
If selected, the trunk will be disabled.
Configure the Caller ID. This is the number that the trunk will try to use when
making outbound calls. For some providers, it might not be possible to set the
CallerID with this option and this option will be ignored.
Important Note: When making outgoing calls, the following priority order rule will
To Next Page
Loading...
Need help?
General
