Figure 49: Set Time Manually
Note: Manually setup time will take effect immediately after saving and applying change in the Web GUI. If users
would like to reboot the UCM630X and keep the manually setup time setting, please make sure "Remote NTP
Server", "Enable DHCP Option 2" and "Enable DHCP Option 42" options under Web GUI→Settings→Time
Settings→Auto Time Updating page are unchecked or set to empty. Otherwise, time auto updating settings in
this page will take effect after reboot.
NTP Server
The UCM630X can be used as an NTP server for the NTP clients to synchronize their time with. To configure
the UCM630X as the NTP server, set "Enable NTP server" to "Yes" under Web GUI→System Settings→Time
Settings→NTP Server. On the client side, point the NTP server address to the UCM630X IP address or host
name to use the UCM630X as the NTP server.
Office Time
On the UCM630x, the system administrator can define "office time" which can be used to configure time condition
for extension call forwarding and inbound rules. To configure office time, log in to the Web GUI, enter the System
Settings→Time Settings→Office Time, and click the "Add" button to see the following configuration page.
To Next Page
Loading...
Need help?
General
