UCM630X Series User Manual
Version 1.0.11.10
This is the order in which the Follow Me destinations will be dialed to reach the user.
Create New IAX Extension
The UCM630X supports Inter-Asterisk eXchange (IAX) protocol. IAX is used for transporting VoIP telephony
sessions between servers and terminal devices. IAX is like SIP but also has its own characteristic. For more
information, please refer to RFC 5465.
To manually create a new IAX user, go to Web GUI→Extension/Trunk→Extensions. Click on "Add" and a new
dialog window will show for users which need to make sure first to select the extension type to be IAX Extension
before proceeding to fill in the extension information. The configuration parameters are as follows.
Table 43: IAX Extension Configuration Parameters→Basic Settings
The extension number associated with the user.
Configure the CallerID Number that would be applied for outbound calls from this
user. Note: The ability to manipulate your outbound Caller ID may be limited by your
VoIP provider.
Assign permission level to the user. The available permissions are "Internal", "Local",
"National" and "International" from the lowest level to the highest level. The default
setting is "Internal".
Note: Users need to have the same level as or higher level than an outbound rule's
privilege to make outbound calls using this rule.
Configure the password for the user. A random secure password will be automatically
generated. It is recommended to use this password for security purposes.
Configure Voicemail.
There are three valid options, and the default option is "Enable Local Voicemail".
• Disable Voicemail: Disable Voicemail.
To Next Page
Loading...
Need help?
General
