1060 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
SECURE SHELL (SSH) COMMANDS
SERVICE
SSH
service ssh
Overview This command enables the Secure Shell server on the device. Once enabled,
connections coming from SSH clients are accepted.
SSH server needs a host key before it starts. If an SSHv2 host key does not exist,
then this command fails. If SSHv1 is enabled but a host key for SSHv1 does not
exist, then SSH service is unavailable for version 1.
The no variant of this command disables the Secure Shell server. When the Secure
Shell server is disabled, connections from SSH, SCP, and SFTP clients are not
accepted. This command does not affect existing SSH sessions. To terminate
existing sessions, use the clear ssh command.
Syntax
service ssh [ip|ipv6]
no service ssh [ip|ipv6]
Default The Secure Shell server is disabled by default. Both IPv4 and IPv6 Secure Shell
server are enabled when you issue service ssh without specifying the optional ip
or ipv6 parameters.
Mode Global Configuration
Examples To enable both the IPv4 and the IPv6 Secure Shell server, use the commands:
awplus# configure terminal
awplus(config)# service ssh
To enable the IPv4 Secure Shell server only, use the commands:
awplus# configure terminal
awplus(config)# service ssh ip
To enable the IPv6 Secure Shell server only, use the commands:
awplus# configure terminal
awplus(config)# service ssh ipv6
To disable both the IPv4 and the IPv6 Secure Shell server, use the commands:
awplus# configure terminal
awplus(config)# no service ssh
To disable the IPv4 Secure Shell server only, use the commands:
awplus# configure terminal
awplus(config)# no service ssh ip
To disable the IPv6 Secure Shell server only, use the commands:
awplus# configure terminal
awplus(config)# no service ssh ipv6
To Next Page
Loading...
Need help?
General
