Allied Telesis AlliedWare Plus AT-x230-10GP - Chapter 34: EPSR Commands; EPSR Commands; Introduction

34
1139 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
EPSR Commands
Introduction
Overview This chapter provides an alphabetical reference for commands used to configure
EPSR. For more information, see the EPSR Feature Overview and Configuration
Guide.
For information on filtering and saving command output, see “Controlling “show”
Command Output” in the “Getting Started with AlliedWare Plus” Feature Overview
and Configuration Guide.
Command List •“debug epsr” on page 1141
•“epsr” on page 1142
•“epsr configuration” on page 1143
•“epsr datavlan” on page 1144
•“epsr enhancedrecovery enable” on page 1145
•“epsr mode master controlvlan primary port” on page 1146
•“epsr mode transit controlvlan” on page 1147
•“epsr priority” on page 1148
•“epsr state” on page 1149
•“epsr trap” on page 1150
•“show debugging epsr” on page 1151
•“show epsr” on page 1152
•“show epsr common segments” on page 1156
•“show epsr config-check” on page 1157
•“show epsr <epsr-instance>” on page 1159
•“show epsr <epsr-instance> counters” on page 1160
•“show epsr counters” on page 1161