40
1330 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
SNMP Commands
Introduction
Overview This chapter provides an alphabetical reference for commands used to configure
SNMP. For more information, see:
•the SNMP MIBs Overview, for information about which MIB objects are
supported.
•the SNMP Feature Overview and Configuration Guide.
For information on filtering and saving command output, see “Controlling “show”
Command Output” in the “Getting Started with AlliedWare Plus” Feature Overview
and Configuration Guide.
Command List •“debug snmp” on page 1332
•“show counter snmp-server” on page 1333
•“show debugging snmp” on page 1338
•“show running-config snmp” on page 1339
•“show snmp-server” on page 1340
•“show snmp-server community” on page 1341
•“show snmp-server group” on page 1342
•“show snmp-server user” on page 1343
•“show snmp-server view” on page 1344
•“snmp trap link-status” on page 1345
•“snmp trap link-status suppress” on page 1347
•“snmp-server” on page 1349
•“snmp-server community” on page 1351
•“snmp-server contact” on page 1352
•“snmp-server enable trap” on page 1353
To Next Page
Loading...
Need help?
General
