C613-50055-01 REV A Command Reference for x230 Series Edge Switches 919
AlliedWare Plusâ„¢ Operating System - Version 5.4.5-0.x
AUTHENTICATION COMMANDS
SHOW
AUTH TWO-STEP SUPPLICANT BRIEF
show auth two-step supplicant brief
Overview This command displays the supplicant state of the two-step authentication feature
on the interface.
Syntax
show auth two-step supplicant [interface <ifrange>] brief
Mode Privileged Exec
Usage Do not mix interface types in a list. The specified interfaces must exist.
Example To display the supplicant state of the two-step authentication feature, enter the
command:
awplus# show two-step supplicant interface port1.0.6 brief
Output Figure 26-1: Example output from the show auth two-step supplicant brief
command
Related
Commands
auth two-step enable
Parameter Description
interface The interface selected for display.
<ifrange> The interface types which can be specified as <ifrange>
• Switch port (e.g. port1.0.6)
• Static channel group (e.g. sa3)
• Dynamic (LACP) channel group (e.g. po4)
interface port1.0.6
authenticationMethod: dot1x/mac
Two-Step Authentication:
firstMethod:mac
secondMethod:dot1x
totalSupplicantNum: 1
authorizedSupplicantNum: 1
macBasedAuthenticationSupplicantNum: 0
dot1xAuthenticationSupplicantNum: 1
webBasedAuthenticationSupplicantNum: 0
otherAuthenticationSupplicantNum: 0
Interface VID Mode MAC Address Status FirstStep SecondStep
========== === ==== =========== ====== ========= ==========
port1.0.6
1 D 000b..db67.00f7 Authenticated Pass Pass
To Next Page
Loading...
Need help?
General
