C613-50055-01 REV A Command Reference for x230 Series Edge Switches 495
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
LINK AGGREGATION COMMANDS
SHOW
ETHERCHANNEL
show etherchannel
Overview Use this command to display information about a LACP channel specified by the
channel group number.
The command output also shows the thrash limiting status. If thrash limiting is
detected and the thrash limiting parameter of the thrash-limiting command is set
to vlan disable, the output will also show the VLANs on which thrashing is
detected.
For information on filtering and saving command output, see “Controlling “show”
Command Output” in the “Getting Started with AlliedWare Plus” Feature Overview
and Configuration Guide.
Syntax
show
etherchannel [<1-32>]
Mode User Exec and Privileged Exec
Example
awplus# show etherchannel 2
Output
Parameter Description
<1-32> Channel-group number.
% Lacp Aggregator: po1
Thrash-limiting
Status Vlan Thrashing Detected, Action vlan-disable 60(s)
Thrashing Vlans 1 2 3 4 5
% Member:
port1.0.4
port1.0.6
To Next Page
Loading...
