C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1235
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AMF COMMANDS
SHOW
ATMF
show atmf
Overview Displays information about the current AMF node.
Syntax
show atmf [summary|tech|nodes|session]
Default Only summary information is displayed.
Mode User Exec and Privileged Exec
Usage AMF uses internal VLANs to communicate between nodes about the state of the
AMF network. Two VLANs have been selected specifically for this purpose. Once
these have been assigned, they are reserved for AMF and cannot be used for other
purposes
For information on filtering and saving command output, see “Controlling “show”
Command Output” in the “Getting Started with AlliedWare Plus” Feature Overview
and Configuration Guide.
Example 1 To show summary information on AMF node_1 use the following command:
node_1# show atmf summary
The following figure shows some example output from running this command for
a specific AMF node.
Example 2 To show information specific to AMF nodes use the following command:
node_1# show atmf nodes
Parameter Description
summary Displays summary information about the current AMF node.
tech Displays global AMF information.
nodes Displays a list of AMF nodes together with brief details.
session Displays information on an AMF session.
Table 35-1: Output from the show atmf summary command
node_1#show atmf summary
ATMF Summary Information:
ATMF Status : Enabled
Network Name : Test_network
Node Name : node_1
Role : Controller
Role : Master
Restricted login : Disabled
Current ATMF Nodes : 3
To Next Page
Loading...
Need help?
General
