1292 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
MANAGEMENT STACKING COMMANDS
MSTACK
COMMAND-NODE
mstack command-node
Overview This command configures the device as an management stacking command node.
This is considered the core of the management stack.
From the command node, you can use the remote-login command to access and
configure other nodes in the management stack.
Syntax
mstack command-node
no mstack command-node
Mode Global Config
Usage A management stacking command node has to be present for a management
stack to form. Only one device in the management stack can be the command
node.
Example To make the device called command-node into the management stacking
command node, use the commands:
command-node#configure terminal
command-node(config)#mstack command-node
To disable the device from being the management stacking command node, use
the commands:
command-node# configure terminal
command-node(config)#no mstack command-node
To Next Page
Loading...
