C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1479
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
TRIGGER COMMANDS
TYPE
CPU
type cpu
Overview This command configures a trigger to activate based on CPU usage level. Selecting
the up option causes the trigger to activate when the CPU usage exceeds the
specified usage level. Selecting the down option causes the trigger to activate
when CPU usage drops below the specified usage level. Selecting any causes the
trigger to activate in both situations. The default is any.
Syntax
type cpu <1-100> [up|down|any]
Mode Trigger Configuration
Usage For an example trigger configuration that uses the type cpu command, see
“Capture Unusual CPU and RAM Activity” in the Triggers Feature Overview and
Configuration Guide.
Examples To configure trigger 28 to be a CPU trigger that activates when CPU usage exceeds
80% use the following commands:
awplus# configure terminal
awplus(config)# trigger 28
awplus(config-trigger)# type cpu 80 up
To configure trigger 5 to be a CPU trigger that activates when CPU usage either
rises above or drops below 65%, use the following commands:
awplus# configure terminal
awplus(config)# trigger 5
awplus(config-trigger)# type cpu 65
or
awplus# configure terminal
awplus(config)# trigger 5
awplus(config-trigger)# type cpu 65 any
Related
Commands
show trigger
trigger
Parameter Description
<1-100> The percentage of CPU usage at which to trigger.
up Activate when CPU usage exceeds the specified level.
down Activate when CPU usage drops below the specified level
any Activate when CPU usage passes the specified level in either
direction
To Next Page
Loading...
Need help?
General
