Allied Telesis AlliedWare Plus AT-x230-10GP - Show System Interrupts

218 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
SYSTEM CONFIGURATION AND MONITORING COMMANDS
SHOW
SYSTEM INTERRUPTS
show system interrupts
Overview Use this command to display the number of interrupts for each IRQ (Interrupt
Request) used to interrupt input lines on a PIC (Programmable Interrupt Controller)
on your device.
For information on filtering and saving command output, see “Controlling “show”
Command Output” in the “Getting Started with AlliedWare Plus” Feature Overview
and Configuration Guide.
Syntax
show system interrupts
Mode User Exec and Privileged Exec
Example To display information about the number of interrupts for each IRQ in your device,
use the command:
awplus# show system interrupts
Output Figure 5-18: Example output from the show system interrupts command
Related
Commands
show system environment
awplus#show
system interrupts
CPU0
27:
1387835593 GIC Disabled 1 iproc_gtimer
29:
0 GIC Disabled 1 twd
62:
0 GIC Enabled 0 IDM
63:
0 GIC Enabled 0 IDM
64:
0 GIC Enabled 0 IDM
65:
0 GIC Enabled 0 IDM
66:
0 GIC Enabled 0 IDM
67:
0 GIC Enabled 0 IDM
68:
0 GIC Enabled 0 IDM
69:
0 GIC Enabled 0 IDM
70:
0 GIC Enabled 0 IDM