958 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AAA COMMANDS
AAA
AUTHENTICATION AUTH-WEB
aaa authentication auth-web
Overview This command enables Web-based Port Authentication globally and allows you to
enable an authentication method list (in this case, a list of RADIUS Servers). It is
automatically applied to every interface running Web-based Port Authentication.
Use the no variant of this command to globally disable Web-based Port
Authentication.
Syntax
aaa authentication auth-web default group {<group-name>|radius}
no aaa authentication auth-web default
Default Web-based Port Authentication is disabled by default.
Mode Global Configuration
Usage There are two ways to define servers where RADIUS accounting messages are sent:
• group radius : use all RADIUS servers configured by radius-server host
command
• group <group-name> : use the specified RADIUS server group configured
with the aaa group server command
Note that you need to configure an IPv4 address for the VLAN interface on which
We Authentication is running.
Examples To enable Web-based Port Authentication globally for all RADIUS servers, and use
all available RADIUS servers, use the commands:
awplus# configure terminal
awplus(config)# aaa authentication auth-web default group
radius
To disable Web-based Port Authentication, use the commands:
awplus# configure terminal
awplus(config)# no aaa authentication auth-web default
Related
Commands
aaa accounting auth-web default
auth-mac enable
Parameter Description
<group-name> Server group name.
radius Use all RADIUS servers.
To Next Page
Loading...
