C613-50055-01 REV A Command Reference for x230 Series Edge Switches 401
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
VLAN COMMANDS
SWITCHPORT
VOICE VLAN PRIORITY
switchport voice vlan priority
Overview Use this command to configure the Layer 2 user priority advertised when the
transmission of LLDP-MED Network Policy TLVs for voice devices is enabled. This is
the priority in the User Priority field of the IEEE 802.1Q VLAN tag, also known as the
Class of Service (CoS), or 802.1p priority. When LLDP-MED capable IP phones
receive this network policy information, they transmit voice data with the specified
priority.
Syntax
switchport voice vlan priority <0-7>
no switchport voice vlan priority
To remove the Voice VLAN, and therefore disable the transmission of LLDP-MED
network policy information for voice devices on port1.0.6, use the following
commands:
awplus# configure terminal
awplus(config)# interface port1.0.6
awplus(config-if)# no switchport voice vlan
Parameter Description
priority Specify a user priority value for voice data.
<0-7> Priority value.
To Next Page
Loading...
Need help?
General
