552 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
IP ADDRESSING AND PROTOCOL COMMANDS
SHOW
IP INTERFACE
show ip interface
Overview Use this command to display information about interfaces and the IP addresses
assigned to them. To display information about a specific interface, specify the
interface name with the command.
For information on filtering and saving command output, see “Controlling “show”
Command Output” in the “Getting Started with AlliedWare Plus” Feature Overview
and Configuration Guide.
Syntax
show ip interface [<interface-list>] [brief]
Mode User Exec and Privileged Exec
Examples To show brief information for the assigned IP address for interface port1.0.2 use
the command:
awplus# show ip interface port1.0.2 brief
To show the IP addresses assigned to vlan2 and vlan3, use the command:
awplus# show ip interface vlan2-3 brief
Output Figure 15-4: Example output from the show ip interface brief command
Parameter Description
<interface-list> The interfaces to display information about. An interface-list
can be:
•an interface, e.g. vlan2
• a continuous range of interfaces separated by a hyphen, e.g.
vlan2-8 or vlan2-vlan5
• a comma-separated list of interfaces or interface ranges, e.g.
vlan2,vlan5,vlan8-10
The specified interfaces must exist.
Interface IP-Address Status Protocol
port1.0.2 unassigned admin up down
vlan1 192.168.1.1 admin up running
vlan2 192.168.2.1 admin up running
vlan3 192.168.3.1 admin up running
vlan8 unassigned admin up down
To Next Page
Loading...
Need help?
General
