1250 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AMF COMMANDS
SHOW
ATMF BACKUP AREA
show atmf backup area
Overview Use this command to display backup status information for the master nodes in
one or more areas. This command is only available on AMF controllers.
Syntax
show atmf backup area [logs] [<area-name>] [<node-name>]
Mode Privileged Exec
Example To show information about backups for an area, use the command:
controller-1# show atmf backup area
Parameter Description
logs Displays the logs for the last backup of each node.
<area-name> Displays information about nodes in the specified area.
<node-name> Displays information about the specified node.
To Next Page
Loading...
