23
751 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plusâ„¢ Operating System - Version 5.4.5-0.x
IPv6 Software
Access Control List
(ACL) Commands
Introduction
Overview This chapter provides an alphabetical reference for the IPv6 Software Access
Control List (ACL) commands, and contains detailed command information and
command examples about IPv6 software ACLs as applied to Routing and
Multicasting, which are not applied to interfaces.
For information about ACLs, see the ACL Feature Overview and Configuration
Guide.
To apply ACLs to an LACP channel group, apply it to all the individual switch ports
in the channel group. To apply ACLs to a static channel group, apply it to the static
channel group itself. For more information on link aggregation see the following
references:
•the Link Aggregation Feature Overview and Configuration Guide.
• Link Aggregation Commands
Note that text in parenthesis in command names indicates usage not keyword
entry. For example, ipv6-access-list (named) indicates named IPv6 ACLs entered
as ipv6-access-list <name> where <name> is a placeholder not a keyword.
Note also that parenthesis surrounding ACL filters indicates the type of ACL filter
not the keyword entry in the CLI. For example, (ipv6 access-list standard IPv6
filter) represents command entry in the format:
[<sequence-number>] {deny|permit} {<IPv6-source-address/prefix-length>|any}.
NOTE: Software ACLs will deny access unless explicitly permitted by an ACL action.
To Next Page
Loading...
Need help?
General
