356 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
SWITCHING COMMANDS
SHOW
PLATFORM
show platform
Overview This command displays the settings configured by using the platform commands.
Syntax
show platform
Mode Privileged Exec
Usage This command displays the settings in the running config. For changes in some of
these settings to take effect, the device must be rebooted with the new settings in
the startup config.
Example To check the settings configured with platform commands on the device, use the
following command:
awplus# show platform
Output Figure 10-9: Example output from the show platform command
Related
Commands
platform load-balancing
awplus# show platform
MAC vlan hashing algorithm crc321
Table 10-1: Parameters in the output of the show platform command
Parameter Description
MAC vlan hashing
algorithm
MAC based VLAN hash control.
To Next Page
Loading...
