C613-50055-01 REV A Command Reference for x230 Series Edge Switches 139
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
FILE MANAGEMENT COMMANDS
SHOW
AUTOBOOT
show autoboot
Overview This command displays the Autoboot configuration and status.
Syntax
show autoboot
Mode Privileged Exec
Example To show the Autoboot configuration and status, use the command:
awplus# show autoboot
Output Figure 3-5: Example output from the show autoboot command
Figure 3-6: Example output from the show autoboot command when an
external media source is not present
Related
Commands
autoboot enable
create autoboot
show boot
awplus#show autoboot
Autoboot configuration
--------------------------------------------------------------------------------
Autoboot status : enabled
SD Card file autoboot.txt exists : yes
Restore information on SD card
Autoboot enable in autoboot.txt : yes
Restore release file : x230-5.4.5-0.1.rel
(file exists)
Restore configuration file : network_1.cfg (file exists)
awplus#show autoboot
Autoboot configuration
--------------------------------------------------------------------------------
Autoboot status : enabled
External media source : SD card not found.
To Next Page
Loading...
Need help?
General
