Allied Telesis AlliedWare Plus AT-x230-10GP - Loop-Protection Action-Delay-Time

332 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
SWITCHING COMMANDS
LOOP
-PROTECTION ACTION-DELAY-TIME
loop-protection action-delay-time
Overview Use this command to sets the loop protection action delay time for an interface to
specified values in seconds. The action delay time specifies the waiting period for
the action.
Use the no variant of this command to reset the loop protection action delay time
for an interface to default.
Syntax
loop-protection action-delay-time <0-86400>
no loop-protection action
Default Action delay timer is disabled by default.
Mode Interface Configuration
Example To configure a loop protection action delay time of 10 seconds, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.4
awplus(config-if)# loop-protection action-delay-time 10
To reset the Loop Protection action delay time to default, use the commands:
awplus# configure terminal
awplus(config)# interface port1.1.4
awplus(config-if)# no loop-protection action-delay-time
Related
Commands
show loop-protection
Parameter Description
<0-86400> Time in seconds; 0 means action delay timer is disabled.