402 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
VLAN COMMANDS
VLAN
vlan
Overview This command creates VLANs, assigns names to them, and enables or disables
them. Specifying the disable state causes all forwarding over the specified VLAN
ID to cease. Specifying the enable state allows forwarding of frames on the
specified VLAN.
The no variant of this command destroys the specified VLANs.
Syntax
vlan <vid> [name <vlan-name>] [state {enable|disable}]
vlan <vid-range> [state {enable|disable}]
vlan {<vid>|<vlan-name>} [mtu <mtu-value>]
no vlan {<vid>|<vid-range>} [mtu]
Default By default, VLANs are enabled when they are created.
Mode VLAN Configuration
Examples
awplus# configure terminal
awplus(config)# vlan database
awplus(config-vlan)# vlan 45 name accounts state enable
awplus# configure terminal
awplus(config)# vlan database
awplus(config-vlan)# no vlan 45
Related
Commands
mtu
vlan database
show vlan
Parameter Description
<vid> The VID of the VLAN to enable or disable in the range < 1-4094>.
<vlan-name> The ASCII name of the VLAN. Maximum length: 32 characters.
<vid-range> Specifies a range of VLAN identifiers.
<mtu-value> Specifies the Maximum Transmission Unit (MTU) size in bytes, in the
range 68 to1500 bytes, for the VLAN.
enable Sets VLAN into an enable state.
disable Sets VLAN into a disable state.
To Next Page
Loading...
Need help?
General
