C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1117
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
DHCP SNOOPING COMMANDS
SHOW
ARP SECURITY INTERFACE
show arp security interface
Overview Use this command to display ARP security configuration for the specified ports or
all ports.
Syntax
show arp security interface [<port-list>]
Mode User Exec and Privileged Exec
Example To display ARP security configuration for ports, use the command:
awplus# show arp security interface
Parameter Description
<port-list> The ports to display ARP security information about. The port list can
include switch ports, and static or dynamic aggregated links.
Table 32-3: Example output from the show arp security interface command
awplus#show arp security interface
Arp Security Port Status and Configuration:
Port: Provisioned ports marked with brackets, e.g. (portx.y.z)
KEY: LG = Log
TR = Trap
LD = Link down
Port Action
-------------------------------
port1.0.1 -- -- --
port1.0.2 -- -- --
port1.0.3 LG TR LD
port1.0.4 LG -- --
port1.0.5 LG -- --
port1.0.6 LG TR --
port1.0.7 LG -- LD
...
Table 32-4: Parameters in the output from the show arp security interface
command
Parameter Description
Action The action the switch takes when it detects an ARP security violation
on the port.
Port The port. Parentheses indicate that ports are configured for
provisioning.
LG, Log Generate a log message
To Next Page
Loading...
