1172 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AMF COMMANDS
ATMF
BACKUP AREA-MASTERS ENABLE
atmf backup area-masters enable
Overview Use this command to enable backup of remote area-masters from the AMF
controller. This command is only valid on AMF controllers.
Use the no form of the command to stop backups of remote area-masters.
Syntax
atmf backup area-masters enable
no atmf backup area-masters enable
Mode Global configuration
Default Remote area backups are disabled by default
Usage Use the following commands to configure the remote area-master backups:
• atmf backup to configure when the backups begin and how often they run
• atmf backup server to configure the backup server.
Example To enable scheduled backups of AMF remote area-masters, use the commands:
controller-1# configure terminal
controller-1(config)# atmf backup area-masters enable
To disable scheduled backups of AMF remote area-masters, use the commands:
controller-1# configure terminal
controller-1(config)# no atmf backup area-masters enable
Related
Commands
atmf backup server
atmf backup
show atmf backup area
To Next Page
Loading...
