Allied Telesis AlliedWare Plus AT-x230-10GP - Power-Inline Priority

516 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
POWER OVER ETHERNET COMMANDS
POWER
-INLINE PRIORITY
power-inline priority
Overview This command sets the Power over Ethernet (PoE) priority level of a PoE port to one
of three available priority levels:
•low
•high
•critical
The no variant of this command restores the PoE port priority to the default (low).
Syntax
power-inline priority {low|high|critical}
no power-inline priority
Default The default priority is low for all PoE ports on the Power Sourcing Equipment (PSE).
Mode Interface Configuration
Usage Select a PoE port, a list of PoE ports, or a range of PoE ports with the preceding
interface (to configure) command. If you specify a range or list of ports they must
all be PoE capable ports.
PoE ports with higher priorities are given power before PoE ports with lower
priorities. If the priorities for two PoE ports are the same then the lower numbered
PoE port is given power before the higher numbered PoE port.
See the PoE Feature Overview and Configuration Guide for further information
about PoE priority.
Examples To set the priority level to high for port1.0.2, use the following commands:
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# power-inline priority high
Parameter Description
low The lowest priority for a PoE enabled port (default). PoE ports
set to low only receive power if all the PoE ports assigned to
the other two levels are already receiving power.
high The second highest priority for a PoE enabled port. PoE ports
set to high receive power only if all the ports set to
critical are already receiving power.
critical The highest priority for a PoE enabled port. PoE ports set to
critical are guaranteed power before any ports assigned
to the other two priority levels. Ports assigned to the other
priority levels receive power only if all Critical ports are
receiving power.