C613-50055-01 REV A Command Reference for x230 Series Edge Switches 1481
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
TRIGGER COMMANDS
TYPE
MEMORY
type memory
Overview This command configures a trigger to activate based on RAM usage level. Selecting
the up option causes the trigger to activate when memory usage exceeds the
specified level. Selecting the down option causes the trigger to activate when
memory usage drops below the specified level. Selecting any causes the trigger to
activate in both situations. The default is any.
Syntax
type memory <1-100> [up|down|any]
Mode Trigger Configuration
Examples To configure trigger 12 to be a memory trigger that activates when memory usage
exceeds 50% use the following commands:
awplus# configure terminal
awplus(config)# trigger 12
awplus(config-trigger)# type memory 50 up
To configure trigger 40 to be a memory trigger that activates when memory usage
either rises above or drops below 65%, use the following commands:
awplus# configure terminal
awplus(config)# trigger 40
awplus(config-trigger)# type memory 65
or
awplus# configure terminal
awplus(config)# trigger 40
awplus(config-trigger)# type memory 65 any
Related
Commands
show trigger
trigger
Parameter Description
<1-100> The percentage of memory usage at which to trigger.
up Activate when memory usage exceeds the specified level.
down Activate when memory usage drops below the specified level.
any Activate when memory usage passes the specified level in either
direction.
To Next Page
Loading...
Need help?
General
