Allied Telesis AlliedWare Plus AT-x230-10GP - Copy Current-Software

118 Command Reference for x230 Series Edge Switches C613-50055-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
FILE MANAGEMENT COMMANDS
COPY
CURRENT-SOFTWARE
copy current-software
Overview This command copies the AlliedWare Plus™ OS software that the device has
booted from, to a destination file. Specify whether the destination is Flash or card
when saving the software to the local filesystem.
Syntax
copy current-software <destination-name>
Mode Privileged Exec
Example To copy the current software as installed in the working directory with the file
name my-release.rel, use the command:
awplus# copy current-software my-release.rel
Related
Commands
boot system backup
show boot
Parameter Description
<destination-name> The filename and path where you would like the current
running-release saved. This command creates a file if no file
exists with the specified filename. If a file already exists,
then the CLI prompts you before overwriting the file. See
Introduction on page 106 for valid syntax.